Honda Civic EG, Del Sol Trailing Arm Bushing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a model of the 92-95 Honda Civic EG/ 93-97 Del Sol trailing arm bushing.
- Ocena
- 4 / 5
- Polubienia
- 18
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 342
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE 9/15/25 A user did a test print and found the old model sizing was off, I've remade the bushing to exact fit per his measurements so it should be good now, if you downloaded the previous version you'll want to redownload the new one.
This is a model of the 92-95 Honda Civic EG/ 93-97 Del Sol trailing arm bushing. I made an easy installation "Split" version so you can just slide them in from each side then secure them together with some long zip ties through the 4 holes I put in (Or you could use bolts and washers but I find it unnecessary).
DISCLAIMER: I haven't personally printed these yet to test fitment, so you might do only one side first to verify it fits*
Note: these are designed to use the stock metal ring and through bolt from your old bushing, so you'll have to remove the old rubber first, you can search youtube for easy methods to remove the old rubber (most people burn it out with a torch but you can use a sawzall too if you want).
NOTE: I highly recommend printing in TPU since bushings are usually made of urethane or rubber, I don't think plastic would hold up or be safe. 100% infill recommended but you might be able to get away with slightly less.
Category: Automotive
If you would like to leave a small tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ