LWC Airsoft Timee268 1911 GBB carbine conversion kit

Now take a look at that thing!  Saw it, loved it. Evenso the Creator intended to CNC  it out of wood, he offered his design as it should print just fine as well.
You can check out his howto blog and also dont forget to leave him a like!
This conversion kit was made for a KWA 1911, but my elite force 1911 does fit as well, so does a KJW- KP07. 
So as long the GBB measurement is the same, this should work with a wide range of different 1911 brands. Most important part is the lower tactical rail on the 1911, where the whole setup is fixed on.
Times Blog: http://imgur.com/a/niNOt

After printing the original files untouched I started to work on it, optimizing the design.  Of course taking it apart to make it easier to print.  Adding screw and nut inlets so it's all clean and flush with the body surface.  Giving the whole design a more rounded appearance by 
Reinforcing the Main Body in the  middle part  and on the mock shell eject window.
taking off sharp corners and lines.
Added some stylish " racing stripes" ;)
created a charging handle+ skeletonized charging case
created side, top and lower Picatinny rails.
lengthened the buffertube inlet for a more stable mount. 
Added my Logo and also the name of the conversion kit.
Added fast detach sling swivel mount option. 
Reinforced the Modell at some points where I had "see throughs" after printing the original kit unmodified.
Created a Mock suppressor
Created a Pistol mount fixation ( prevents pistol being kicked out from mounting through blowback action)
Created additional Pistol Grip Guard ( AUG Style) for picatinny Rail.

15x M4x30mm screws + nuts
10x M4x15mm screws+ nuts
1x special length ( you have to figure out yourself) m4 screw for fixing the gun in the carbine conversion kit
( Yes those are more than you actually need, but you know screws drop easily and get lost a lot ;) 
*****************************************************************************************************
!!!!ATTENTION!!!!!! After a while and several Magazines I encountered a problem in the design. I am using a real hard kicking KJW KP-07  CO2 Pistol who kicks the gun backwards and out of the mount!!

the only working way to fix this is to drill a hole on the bottom side of the tactical rail and cut a thread. A Screw is then put through the lower frame and the pistol frame, holding the gun in position!!!   A picture was added so you can see what you have to do, also VERY IMPORTANT DONT USE A TOO LONG screw!!!

 Otherwise you will block the Slide from cycling!! If you dont pay attention you will BREAK YOUR GUN!!
Testfit the bolt  more often and SHORTEN it with a file if needed!!

I am not responsible if you break your gun just because you didn't read the instruction carefully!!!