1 / 3
Shelly H&T Mount for Original Prusa Enclosure — zdjęcie 1
1 / 3

Shelly H&T Mount for Original Prusa Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Shelly H&T Gen3 mount for Original Prusa Enclosure

Ocena
0 / 5
Polubienia
4
Pobrania
10
Wydruki
0
Wyświetlenia
174
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I wanted to mount a Shelly H&T Gen3 in my Prusa Enclosure. The plan was to control the enclosure fan based on the temperature inside (using Home Assistant for that, simple on/off). This model is what I came up with to help solve that problem. Split into two parts so that the part that attaches to the Shelly sensor could print in the strongest orientation. 

Parts Needed:

  • 2 x M3 nuts
  • 2 x M3x12 socket head cap screws

You may also want to add the following for keeping the slide in the mount. I didn't bother with this as the friction fit was good enough, but I added holes for these screws for those that might need them. 

  • 2 x M3x8 socket head cap screws (Optional)

Has enough room for a cable to power the sensor - didn't want to deal with batteries in the enclosure. 

Print Settings I used:

  • PETG, since this will be inside the enclosure.
  • 0.2mm layer height
  • 20% infill
  • I used supports on for the inside, where the M3 nuts would be installed, but you can likely get away without them.

Tagi