1 / 4
DAA Lynx belt link 0.75" Chicago screw drill jig — zdjęcie 1
1 / 4

DAA Lynx belt link 0.75" Chicago screw drill jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Drill your DAA Lynx links to direct-mount accessories with standard 0.75" hole spacing with this handy jig.

Ocena
0 / 5
Polubienia
5
Pobrania
64
Wydruki
0
Wyświetlenia
467
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

This jig allows you to drill straight, perfectly-spaced 13/64" holes in DAA Lynx belt links, so you can screw your equipment directly to the belt using Chicago screws, thereby preserving the belt's flexibility and increasing its attachment strength by leaving more of its hooks in contact with the inner belt's loops.

Print Notes

Print the bottom half of the jig with its underside on the print bed. Print the top half of the jig upside-down, with the guide pins pointing upward. It won't need supports in that orientation.

I printed with four walls, which makes the guide pins a bit sturdier.

Usage Notes

Press the link into the bottom half of the jig. It only fits one way. (It will probably be a tight fit. Inserting the side with the two larger bosses first, on the right when looking at the outside of the link, works best for me.)

Put the top half of the jig on, aligning the guide pins with the appropriate holes to position it. The triangle mark on the top half of the jig points toward the top of the link.

Set the jig on a scrap of 2x4 or something and drill away, using the guide holes to direct the drill bit. The guide holes are sized for a 13/64" drill bit, which fits my Chicago screws perfectly.

The drill guide holes should be centered horizontally on the link and symmetric around the vertical center of the link. The jig is keyed to only work in one orientation in case I made any errors in measurement or drafting.

Tagi