1 / 3
Epsilon w50 orca slicer pla print profile_orca cube — zdjęcie 1
1 / 3

Epsilon w50 orca slicer pla print profile_orca cube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

print profile using orca slicer for printer epsilon w50

Ocena
0 / 5
Polubienia
2
Pobrania
71
Wydruki
0
Wyświetlenia
194
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Attribution

This is a custom printer profile to use the Epsilon w50 printer with Orca slicer.

Profile is tested with pla. 

You can modify it and use with other material. 

Print quality encrease a lot respect the original ones.

The printer is idex, with this profile you can use only 1 extruder a time, i need to complete the full configuration with 2 extruder.

To use T1 extruder instead T0 change T0 in the exported g.code using notepad++

Only change did in the hardware was changing the nozzle with an bondtech high flow 0.4mm,

Due to the different height of that nozzle respect original ones you need to higher a little the hotend with shims enaught that the hot block don't touch the alluminium mount. 

if it touch the alluminium mount the pid calibration doesn't work.

it works also with original nozzle but not with all material, bondtech hogh flow nozzle helps a lot with the printing quality.

Enjoy