Unifi Switch8 60W Mount

I couldn't find a model that printed easily or without supports so I decided to make my own. This model is meant to hold the switch from the bottom and is designed to still allow access to the grounding screw should you need to use it. Mounts to the wall using two M4 countersunk screws a.k.a. the smallest Ikea screws I had at the time.

I printed mine with Elegoo Rapid PETG in White on a Bambu Labs P1S. Print used about 26g of filament and took 45 minutes to print with three (3) wall loops with 25% gyroid infill. I am sure you could go a bit lower on the walls and infill without a problem. 

Hopefully this model proves helpful to others. While not necessary, donations are always welcome.

EDIT - 12/23/24 - I realized that it would only take a few minutes to make a second bracket that could also be used for an under desk mount, so I made that too. That said, I've not test printed this second .stl file. If you do print out the “Upper Bracket”, please let us know how it works for you.