Ryobi Leafblower extension

I printed this part out of PETG with 4-5 walls and 10% infill basically prints the walls solid. I had to print these in two parts as they are too big for my printer. The mating parts have an interference fit that okay, not perfect, but not poor, just okay. Maybe Ill fix this some day maybe I wont, however the part works. You can seal the small crack with some silicone or glue but I didnt. I couldn't notice much of a degradation in performance from this gap especially against the smashed version. One other small issue is  base part isnt 100% square with the tool face which is annoying but again its good enough to be functional and maybe someday Ill revise it. 

Hope this can get someone out of a bind and make a temporarily permanent fix.