Emergency 10mm holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The perfect storage for one 10mm socket
- Ocena
- 5 / 5
- Polubienia
- 463
- Pobrania
- 500
- Wydruki
- 2
- Wyświetlenia
- 8004
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Printing:
All parts can be printed with your printers standart settings in PLA. No supports or any special treatment is needet. You may need a brim on the letters, depending on your printerd bed adhetion.
You only need to print one of the holders.
To get the inside of the case white une the colour change feature of your slicer.
If you own a Prusa printer you can unse the attached gcode to print the case with a red outside and white on the inside. Its sliced for the MINI but also works on the MK3S+ (both with 0.4mm nozzle).
Assembly:
If used remove the brim from the letters. Then glue them to the lid. On the back glue the magnets in to the holes. The orientation does not matter.
If you want you can glue the plexiglas into the back of the lid. If only a protection against dust is needed, you can use the clear part of the asshole blister packaging.
Screw the screws into the holes in the case until the head is flush with the top edge.
Glue the holder into the case. Double sided tape is reccomendet, so you can change between 1/4" and 3/8" sockets later.
Put the case up the wall and insert a socket. Cover with the lid.
Additional needed hardware:
2x M3x8 screws
up to M3x20 is possible, shortest is reccomendet. Head type doesn't matter
2x magnets Ø6x2mm
1x Plexiglas 90x90mm
some glue / double sided tape