Lenovo Tab M10 Plus 3rd Gen Wall mount

This is untested for now. Not sure how the ribbon cable will fit during installing and removing, hopefully the space will be enough. For me its above a hole, so it should work, but keep that in mind before printing!

Printing orientation:  It should be printed on the side where the usb-c port is. This way it prints nicely without the need of supports.

Known issues:

-I forgot to modify the counterbore after reducing that surface, easily fixable with a 6mm drill bit

-Its a bit wiggly, it doesnt fall out, but its not in tightly.  I wrapped some electrical tape on the back to make it more tight. Probably I wont fix this since tolerance can be tricky between printers and fixing it with tape is a lot easier than reprinting if it gets too tight.

I wanted to have a tablet mount that is not as big as most other models (this one is only 13 mm thick), but still has hidden power connectors on it. The original model from @nischno_2060487  seemed to be perfect for my needs, just needed some modification. Huge thanks for uploading the step file, it saved me the time for remodelling!

I ordered this usb C connector for it:
https://www.aliexpress.com/item/1005007016102449.html?spm=a2g0o.order_list.order_list_main.5.9f601802hKAwHf

I dont have the cable yet, so the design is only tested on table, which seems to be good enough. Gonna update after I recieve it.