Blush (Crush/Rush Blaster Remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Crush, but reworked to hit some semi-custom wants from a few Bay Area nerfers.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 130
- Wydruki
- 1
- Wyświetlenia
- 1377
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Changelog:
2/24/25: Replaced Blush Plunger with Rush Unified Plunger, which is the proper part. This has been tested to work with Blush, Reaver, and should also enable future machined plunger designs.
1/30/25: Replaced Rush PT Front with Blush PT Front since the threaded rods don't line up. Added Blush Mag Release Short Catch (thank you Dingus) for lower travel - use if mags get stuck at the release.
=====
Full documentation pending.
This is a complete model of the Blush remix featuring:
X spring compatibility
Adjustable spring rest - print the “Adjustment Wrench” part and install 2x M3x12 screws, OR print the ToolCap parts for integrated tooling in handle.
No linear rail
Print everything that is not in the Archive folder. Any part not labeled “Blush” has been unchanged from the source blaster.
=====
ToolCap needs some additional revisions as of 1/14/25 to help with threaded rod installation but you'll only need to reprint parts - no hardware will be lost. It holds 2x M2.5 allen keys for adjusting the spring rest and uninstalling M3 screws, as well as a wrench for extracting the threaded rod and nut.
Additionally requires 1x each of: M3 brass heatset, M3x6 socket screw, M3x12 socket screw, M3 thumbscrew 10-18mm long, 6-32 nut.