1 / 9
450 Bushmaster Magpul P-Mag Magazine Follower — zdjęcie 1
1 / 9

450 Bushmaster Magpul P-Mag Magazine Follower

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

UPDATED! Mk 2 file attached. Converts Magpul P-mag 20 300 Blackout magazine into a 5 round 450 Bushmaster Magazine

Ocena
0 / 5
Polubienia
7
Pobrania
170
Wydruki
0
Wyświetlenia
821
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Public Domain

***This is an updated version of the original which functioned perfectly in testing at the shop with dummy ammo, but failed to lock the magazine back in live fire.  The changes are small enough that I've not updated the photos, but the Mk2 STEP file has replaced the original.***

This is a magazine follower that sits on top of the standard Magpul P-mag follower so 450 Bushmaster ammo can be run in the mag.  I used a Magpul P-Mag for 300 blackout, but I have no doubt that the 5.56 mags would work as well.  A P-mag 20, 20 round magazine will be converted into a 5 round 450 Bushmaster magazine using this follower and with a permanent mod to the magazine.

There is a rib down the center of the front of the magazine that separates the bullet tips and acts as a front upper limit for the follower.  This will need to be removed as shown in the photos.  I used a narrow wood chisel, but a file could be used as well.  The 450 Bushmaster ammo will not fit in the mag with this rib in place.

Additionally, on the 5.56 versions of the magazines, there is a small flat near the top on each side of the mag that holds the 5.56 ammo slightly towards the centerline of the magazine. It can be seen in the picture with the grey follower pressed down a half inch. I suspect these flats, which are not present on the 300 Blackout versions of the magazine will have to be filed off in order for the follower to clear.  You may be able to file the sides of the follower as well.

I printed in PLA with a .4mm nozzle and with a 0.12mm layer height and 4 shells with 5 top and bottom layers.  30% fill with a triangular pattern set to start at 60°, but as the part is in compression under use, I suspect it could be printed in any manner of ways.