Case for AdaFruit White LED Backlight Module
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
Update: This was the final version. Good balance and ability to deal with multiple badge holder types. Threading the wires is still difficult, BUT very reliable. Thread them through and bend them around to get a good contact.
This is a case for White LED Backlight Module - Large 45mm x 86mm.
- Product page: http://www.adafruit.com/products/1621
- Data sheet: http://www.adafruit.com/datasheets/KWB-R8445W-1W.pdf
This is my first attempt at a 3d print design. Wanted to use these as nametags.
Threading the wires is still not optimal. There is probably a better way. The holder is sized for a CR2032.
Print Settings
Printer:
M3D Micro
Rafts:
Doesn't Matter
**Supports:**
Yes
Notes:
Not sure the best way to print it. If you print it battery cover down you end up with supports there, face down might be better, haven't tried it (yet).
How I Designed This
Started by looking at the data sheet to get the dimensions. Initial plan was to just tape the battery to the back, but then it evolved over time.