glueless holder for Aqara Motion Sensor P1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
glueless "slide in" holder for aqara Motion Sensor P1 & aqara swivel holder
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 315
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi, my first Printable share! 😊
as i dont like to use the original aqara adhensive pads for mounting, i made a "slide in" holder for my aqara Motion Sensor P1. You can srew on the base holder and slide-in the aqara swivel-mount and P1 Motion Sensor device without gluing. Floor and ceiling mounting possible, simply turn device upside down to get best detection range... after beeing mounted, you can turn swivel base easily to adapt angle of tilting! (without my holder and original adhensive pads you would had to decide correct angle and position before gluing!)
NOTE: spaces are designed for use with original adhensive foam pads! Without adhensive foam, gaps might be to wide! (you could use a folded cardboard as spacer and spring, for tight fit) With foam pads (right out of the box), it slides-in smoothly and holds firmly! 😁 IMPORTANT: Keep protective foils on adhensive pads, before sliding in this 3dprint holder!!!
on my cheap&slow Anycubic Kobra, i had to use supports for PLA. i printed with PLA (PETG was to sticky for supports), with cura tree support, support density 0!!!(more than 0% support densitiy you cant even break out support with pliers!!!), support-z 0.3 i was able to break out support carefully from small gaps with a 2mm swivel... a small , but stable screwdriver might do the same... to get out support from the small gaps where the most challanging!
enjoy!
Category: Electronics, Smarthome