UT47 Kishy Signature
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hi there! Finally getting around to uploading the UT47 v1 Kishy Signature case I designed last summer. This is the…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 312
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Hi there!
Finally getting around to uploading the UT47 v1 Kishy Signature case I designed last summer. This is the first keyboard case I designed, so it isn't perfect, but it came out pretty nice!
You will need M2 brass heat-set threaded inserts, as well as 6 of the screws and standoffs that came with the board, along with M2x3 screws for attaching the plate into the case. I designed it to work with these USB-Micro breakout boards: https://bit.ly/2IxVRSE , so you will need one of those in order to connect it to the board.
This case will only work with the UT47v1 plate, not the v2. It will have a fillet on the top half of the case, which is not pictured in the one I made - this was due to an error on my part that left it out, still came out alright though!
Again, it isn't the cleanest design, so there is a bit of fiddling to get it assembled, but I think it's worth it! Please share if you make one, there are only 2 existing as of now!
Category: Electronics