VTX mount for Walksnail mini 1s kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mount for the Walksnail mini 1s kit's vtx is the same width and length as the Walksnail Moonlight vtx.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 193
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I made this mount for the Walksnail mini 1s vtx so I could swap it into planes that had a hole cut for the Walksnail Moonlight vtx to friction-fit in the plane, and have a bit of protection too.
The bind button and usb cable port are still accessible on the sides with the mount screwed together. There is a tapered hole in the top of the mount for the antenna to be held in place by with a friction fit. The mount also helps hold the antenna connection on the vtx into place a bit better.
The mount has holes for 4x M2x8 screws to hold the vtx in place in the mount. The screws pictured are M2x12, which are too long and stick out a bit.
I suggest printing with PETG, ASA/ABS, or a more heat-resistant filament, because this vtx gets very hot, and would probably melt PLA.
I printed with 0.20 layer height, 15% infill, no supports, on a MK4.