Tilted Gridfinity Drawer For Pegboards With Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of a tilt drawer I have seen made for honeycomb and skadis but for pegboard AND Gridfinity.
- Ocena
- 5 / 5
- Polubienia
- 56
- Pobrania
- 148
- Wydruki
- 1
- Wyświetlenia
- 957
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of a tilt drawer I have seen made for honeycomb and skadis but everyone forgets that poor unsung hero, the normal pegboard! I added a mount for a 1-inch spaced pegboard, as well as 1x3 Gridfinity base and a handle for easier opening. No hardware needed, just make sure to print with supports due to the handle and pegs.
I set this up with tree supports but found I had to clean a tiny piece of tree support in one of the tracks with my rotary tool, maybe traditional supports work better. It only took 30 seconds to fix but just be aware, maybe you can use deburr tool if it happens for you too. There is room on the plate to print some Gridfinity bins as well. 1x1, 1x2, 1x3 bins from this collection should work.