1 / 1
Happy New Years 2025 Bobble Stars Hairband
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bobbling and jiggling year 2025 above your head add a little more festivity with bobbling stars to help.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 241
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Happy New Years 2025 with this bobble year and stars hairband!
Recommendations
Filament
PETG filament is flexible enough for the bobble section to bend almost 90 degrees without snapping. PLA+ has a bit more flexibility than PLA but not as must as PETG and is a good alternative material for this print. PLA is not as flexible; however, it is strong enough to avoid snapping except under vigorous movement - it just won't bobble as much.
Slicer Settings
Bobble Top:
- Print orientation - must be flat and rotated to 45 degrees to fit on a 220mm print bed.
- Layer height - 0.2
- Wall line count - 2
- Top layers - 3
- Bottom layers - 3
- Infill density - 5%
- Infill pattern - lightning
- Support - None
- Build plate adhesion - None
Hair band:
- Print orientation - flat with opening for bobble insert facing up
- Layer height - 0.2
- Wall line count - 4
- Top layers - 3
- Bottom layers - 3
- Infill density - 5%
- Infill pattern - lines
- Support - None
- Build plate adhesion - None
Assembly tips:
- The bobble section needs to be inserted into the hairband opening at the top of the hair band. This is a snug, snap fit. Sand the ball of the bobble section slightly if needed until it slides in with just a little force required. The interface fit will depend on your 3d printer accuracy. Tolerance used was 0.3mm.
- Add a dab of super-glue to the hairband/bobble section joint to secure it. Hot glue may also work.