JBL Clip 3 zip-tie Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a zip tie assisted bike mount for the JBL Clip 3. Currently works on bikes with a flat top tube, will probably…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 860
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution
This is a zip tie assisted bike mount for the JBL Clip 3.
Currently works on bikes with a flat top tube, will probably upgrade later to fit common round top tubes.
Demo video - https://youtu.be/nCgbRD90aPQ
Works great as a general-purpose mount for the clip 3 as you can zip tie it to anything.
Inspired by this video from Reddit - https://www.reddit.com/r/functionalprint/comments/h8szg1/snapfit\_speaker\_mount\_with\_extra\_layer\_of/
Couldn't find the file anywhere, OP didn't share it in the comments, so I went and made my own.
Supports are recommended, at an angle of 33 degrees.
I use support blockers in Cura in order to make sure there are no supports on the zip tie and button holes, although it is usually not a problem removing these supports.
Managed to print it on a stock Ender-3 without supports at 0.3 layer height and speed of 100 mm/s, but for the best results, supports are recommended.
Currently, the zip tie holes are very thin at the bottom (around 1mm). It does hold on, but I will make them thicker for a more fail-proof design.
**The model exports 90 degrees sideways, I now rotate it in the slicer until I will find the reason...
*EDIT: F3D file now available, sorry it took so long
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
No
Supports:
Yes
0.15-0.2
Infill:
100%
Filament:
Generic PLA Green
Category: Sport & Outdoors