1 / 6
Klask Biscuit
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Klask game biscuit with characteristics very close to the original one
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 193
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution
A Klask game biscuit with characteristics very close to the original one. Uses 4x1mm magnets.
Notes on magnets
3 magnes sizes supported:
- 3x2: untested, but should be close to original (this is the original magnets size)
- 4x1: tested, recommended (behaviour very close to original)
- 5x1: tested, not recommended (magnets are stronger than the original ones)
Print notes
- No supports needed
- Set up a pause on the last layer before the magnet hole is getting closed, push the magnet in and then restart printing
- Note that the south pole of the magnet should be pointing towards the top! If in doubt, compare with the original magnet
- I played with settings to get the closest characteristics to the original and I recommend these: 1 top shell layer, 1 bottom shell layer, 1 wall loop, gyroid 56% infill
If you have the original one for reference, compare it after the printing (if you have precise scales - by mass, but also by the distance from the striker magnet where it gets attached to it.
Updates log
- 2025-09-27: added 3x2mm version
- 2025-01-09: V2 added (4mm). The new version behaves closer to the original in terms of weight distribution / magnet force
- 2024-12-29: Initial version released
Support the author
The model is free to use and published under CC-BY licence, however if you want to support the model author you can do it here: BuyMeACoffee