Artillery Sidewinder X4 Filament Guide - Sensor Mod - Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed X4 Filament Guide that is a bit wider to prevent sagging
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 137
- Wydruki
- 0
- Wyświetlenia
- 595
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I printed the original model for my Atillery Sidewinder X4 Pro. After a while the screw came loose and sensor rotated downwards which made the filament move less smooth than before.
So I made this remix based on @waintdeir's model, increased the distance between screw hole and edge by 4,5 mm so that it's equal to the distance in the stock part. Therefore even if the screw loosens over time the filament sensor cannot sink.
I also added a small rib for stability (somewhat similar to the stock part).
Doesn't need support, ironing top surfaces is possible