Proxmark3 RDV4 with BlueShark Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A protective case for your Proxmark3 RDV4 with BlueShark attached
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 409
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- GNU General Public License v3.0
Worried about snapping your Proxmark3 antenna off whilst it bumps around in your bag? This is the case for you. No openings whatsoever aside from the lid, which is held on with some ratchet teeth.
Print Settings
These are the settings I've tested with, though there's nothing so special about this model that means you can't try other settings (though a finer layer height may be important for the ratchet teeth).
Nozzle: 0.4mm
Layer height: 0.1mm
Material: Prusament PCCF
Orientation
- Print the lid on flat on its head
- Print the case with the wider, open end facing upwards.
This case orientation avoids needing to perform bridges around the perimeter where the latch ends. However, it does make the case top-heavy whilst printing. If this causes you an issue (such as detachment - though it shouldn't), the case can also be printed upside down, but you may get issues where the latch ends - depending on the material, this could be bridge sagging or temperature sag as the fans kick up for your bridge, which can result in a slight bulge.