Mio 4 spot Refrigerator magnet version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I grabbed your 4 spot holder and added a backing wall to accept 4 of my 2.7x10mm magnets.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I grabbed your Mio 4 spot holder rack and added a simple backing wall to accept 4 to 16 of my 3x10mm (2.7 x 9.9)mm magnets. I use a 0.6mm nozzle so I made the clearances a bit more than I usually would. And I printed 4 little rectangular plugs to add into the top after inserting the magnets. Using only 4 magnets might not be strong enough so i jammed in 2 magnets into each slot. I'll secure the magnets and plugs with CA glue.
I will probably reprint it in PLA with a smaller nozzle since this 0.6mm nozzle and PETG is quite stringy.
EDIT: Added a version with 8 slots total. I wasn't confident in the holding power so this should allow for up to 16 magnets if needed. 16 may be overkill but it definitely holds them :)