NCO Sword Tip saver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tip saver for NCO sword
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
want to hang your NCO sword on the wall but worried someone might run into the tip and cut themselves? this great little thing I wiped up slides onto the tip of the sword and should protect anyone that could bumb into it better then the piece of foam that my parents were using. just cut a small strip of foam to keep it snug and slide it onto the sword.
printed in 20% infill PLA at 190C took about 31 minutes. be careful with supports as this thing is quite fragile and taking them out can be difficult and damage the part.
this is mainly to protect the kids and grand-kids that come over to my parents house.