1 / 6
Desktop Stand or HSW Hanger for 7inch Geeekpi Portable Display (52Pi EP-0186) — zdjęcie 1
1 / 6

Desktop Stand or HSW Hanger for 7inch Geeekpi Portable Display (52Pi EP-0186)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This stand doubles as a desktop stand or a Honeycomb Storage Wall hanger for my Geeekpi display case. May hold others.

Ocena
0 / 5
Polubienia
2
Pobrania
17
Wydruki
0
Wyświetlenia
170
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

 My Geeekpi display case requires at least a desktop stand, since the feet supplied with the display do not fit once the case is installed.

I happen to have a section of Honeycomb Storage Wall (HSW) installed along the front of my printer table, and I wanted to hang the display on that wall.

The drill hanger looked strong & was very simple to remix for my purposes and the resulting model serves equally well as a desktop stand.

I printed this in PETG in roughly 3hrs 25mins, at:

  • 10% infill
  • 0.32mm layer height
  • 0.45mm line width
  • 100mm/s infill speed
  • 50mm/s wall speed
  • tree supports for short side bridge, but no other supports required

 

CAUTION:  

  1. Because of the orientation of the Ethernet connector and its close proximity to the Geeekpi case, one needs to use tweezers to release the lock on the connector to disconnect it from the pi.
  2. To secure my display in this cradle, I added a small blob of “blue-tack” at each end of the cradle. [optional]