Perry the platypus (Agent P) — Phineas and Ferb

Perry the platypus – Agent P from Phineas and Ferb cartoon.

Files:

• body

• hat **

• nose

• left_hand

• right_hand

• left_leg

• right_leg

• tail

• right_eye – outer (biggest) white part of a right eye

• right_eye (1) – inner (middle) black part of a right eye

• left_eye – outer (biggest) white part of a left eye

• left_eye (1) – inner (middle) black part of a left eye

• right_eye_ams

• left_eye_ams

• Perry_the_platupus.step — step file

• P_perry_the_platypus v14-all-stl (zip with all the stl’s)

• Everything-!not for printing! — just for show, not for printing 

• Everything-print.3mf — not tested. Should print well all at once

Everything is optimized to be printed with PLA. If you use other materials check the material shrinkage setting for nice fits. 

Needs a bit of assembly:

• Insert hands to the body from both sides. Pay attention to left and right.

• Insert legs to the bottom of the body. Pay attention to left and right.

• Insert tail to the back of the body.

• Assemble eyes*

• Insert eyes assembly to the body. Pay attention to left and right.

• Insert nose to the body

• Hair – same as center of eyes. Insert a thin filament extrusion.

ATTENTION: All parts are press fit. No need for glue or any other adhesives.

Suggestions:

• layer height: 0.2mm works best for everything except a hat, !for hat 0.1mm!

• 2 walls

• cubic or gyroid 10% infill

• Ironing looks fun, but not necessary

• Everything prints with no supports, except for hat. Tree supports work best

* Eyes have 2 files to print for each. The thin white part (see the photo) inside is: extrude some white filament to the air, it should form an even string. Experiment with a speed of extrusion to adjust final part thinkness. It should fit snugly to the apple of the eyes

** Hat must be printed with 0.1mm layer height and tree supports. Make sure to orient the hat right. It has a flat bottom. 1st revision. Will be improved later on.

If you have an AMS like system, you can skip all the hassle with eyes and print everything on one go. 

And if you're really confident, you may try to print everything in one go with supports (Everything-print.3mf (contains colors)) except hair. (Not tested)

If you have any suggestions – post comments, or mail me: [email protected]