Yet Another Toy Train (EZ Print with Magnetic Connectors and Large Variety of Cars)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Another toy train with ten different car types.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 126
- Wydruki
- 0
- Wyświetlenia
- 565
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution
This is an EZ print, magnetically attached toy train that I did for my youngest grandson using OpenSCAD.
The set includes an engine, tender, box car, dining car, dump car, hopper, flatbed car, tank car, gondola car and caboose.
The magnets in this version are embedded in the model to reduce swallowing hazard. Each car requires two (2) 20mmx10mmx5mm magnets except the engine which requires one (1). When printing any of the pieces, place a pause command at layer 44 in the slicer software if using .15mm layers and place magnets in the cavity at the end of the car. Make sure magnet polarities are properly biased. Each car requires six (6) wheels, except the tender, which requires four (4).
- Layer height: 0.15mm
- Infill 15%
- Perimeters: 2
- No Supports
(I originally planned on using 6mmx2mm magnets, but they were not strong enough to hold all of the cars. When printing over the longer magnets, you may want to cover the top with a piece of blue painter's tape to ensure adhesion of the covering print layer.)