1 / 4
Qidi X max 3 Y axis repair. Y axis motor mounts and front idlers — zdjęcie 1
1 / 4

Qidi X max 3 Y axis repair. Y axis motor mounts and front idlers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

this is my design of the X max 3 Y axis drive system. they are self tensioning. printed out of ABS-CF

Ocena
0 / 5
Polubienia
29
Pobrania
126
Wydruki
0
Wyświetlenia
628
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is the Y axis on a X max 3 with significant strength upgrades.

Use the existing rods and pulleys off the originals. 

there is a lot of supports used. I have attached a .3mf file as an example. ( you can print this and be happy )

4 walls min

5 bottom

5 top

40% infill 

you will need 4 5mm rods cut to 53mm long. ( I recommend silver steel, buy it off ali express or so, because it's accurate. these are the new guide rails for the tension pulleys in the back. )

about 6 M3 brass inserts 

6 round headed screws around 10mm to 8mm long or so. 

2 M4 brass nuts ( then use the m4 screw that is used to keep tension on the pulleys in the back.

2 springs.   10mm OD 28.6mm long 1mm wire thickness 

Use a nice 5mm drill to clean out the holes on the tensioner parts and the rear gantry supports. so they run smooth on those 5mm rods. 

 

sand the parts that need to be smooth for all the pulleys. including the faces for the tensioners to run on.

 

the front idler part is identical, just flipped upside down, so printing it out twice will be fine. 

 

the 2 washers are for the spring tensioner, make sure it goes infront of the m4 bolt….should make sense as you build it.

 

good luck and hopefully this is enough info for anyone looking to fix their x max 3.

Tagi