Print in place Toy Car Dodge Ram 1985
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a print in place scaled (1:43) remix of the DODGE RAM body I used for my RC CAR V2. (Size: ca 13x5x5 cm)
- Ocena
- 5 / 5
- Polubienia
- 116
- Pobrania
- 1149
- Wydruki
- 4
- Wyświetlenia
- 3098
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
6/1/25: I'm adding a version with no interior (DodgeRamFull) which should be safer for kids. It prints slightly faster as there is less perimeter.
The NewDodge version is nicer but when pressing on the cabin (or falling on the floor) it could break and make sharp edges.
----------------------------------------
This Dodge Ram (ca 1985) toy car / truck prints pretty nicely at 0.2 in PLA with no supports; the upper side is better as always but the printbed side is fairly good too.
The wheels spin, but not on a hard surface like a desk (!) But it will be perfect for a couch or a carpet…
If you own a Prusa MK3S you can use my print file as is; otherwise look at my orientation choice (steering wheel side is on the build plate).
(And yes there is a steering wheel in this print in place design !)