desklamp based on an Elbro E27 8921-02 provisional lamp holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I had a lot of Elbro E27 8921-02 provisional lamp holders laying around and wanted to give them some use. So I…
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 653
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
I had a lot of Elbro E27 8921-02 provisional lamp holders laying around and wanted to give them some use. So I designed this Lamp.
(maybe I'll do a version for other ones, if there is demand)
Print Settings
Printer Brand:
Anycubic
Printer:
Predator
Doesn't Matter
Supports:
Yes
0.3mm (could also be lower)
Infill:
20%
Filament:
3DJake, DasFilament PLA White, Nature
Notes:
- The Lampshade has a wall width of 0.63mm, so you can print it in Vase mode with a
0.63mm line width
place support blockers at the slots for the M3 nuts in the bottom piece, supports would be
close to impossible to get out of there (there is enough tolerance for some sagging) Material required
2x M3 20mm bolts + nuts
2x M2 PC screws 3.5mm
You can use any screws with about 2mm inner diameter and max 3.5mm length
1x Elbro E27 8921-02 provisional lamp holder
1x Lightbulb
I used a TRADFRI from Ikea, to integrate the Lamp better.
Bulb and Switch:
https://www.ikea.com/ch/en/p/tradfri-dimmer-kit-10435926/
(Switzerland)
1x Cable
Here I used a SYMFONISK cable for looks, but similar cables should work as well.
There is also a version for a 7mm round cable, but there is no real use for the ground wire.
SYMFONISK cable:
https://www.ikea.com/ch/en/p/symfonisk-power-supply-cord-textile-white-20492332/
(Switzerland)
Category: Decor