led strip clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
clip for 10mm (3/8") led strips
- Ocena
- 5 / 5
- Polubienia
- 68
- Pobrania
- 304
- Wydruki
- 6
- Wyświetlenia
- 747
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
LED strip clip
I wanted to have a minimal, very easy to print led clip (since original tape lasts 1 week..), so the design opted for a no support, no brim, perfect print, quick print and small filament requirements (< 1 gram).
Sleek minimal design, compact clip that fits standard 10mm (3/8") led strips.
Easy to print perfect, and only 5 minutes per clip.
Print with the flat "top side" down on build plate, 100% infill and no support or brim.
Made for 3.5mm (1/8") screws, it will fit bigger and smaller screws as well since it's countersink.
There are two versions available, rounded and square (round in picture below)
There are two versions available, rounded and square (square in picture below)
There is one with round corners as well, 1 microgram less filament needed ;)
