1 / 3
Makita Biscuit PJ7000 additional fence
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple bolt on fence for the PJ7000, no permanent modifications to the tool necessary
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 137
- Wydruki
- 1
- Wyświetlenia
- 876
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (40)Powiązane
This simple fence makes it easier to use the Makita Biscuit joiner vertically. It simply bolts into some factory holes at the rear of the bottom sole. There are two small inserts that prevent some M6 nuts from spinning inside of the case. The fence was printed in PETG-HF and is suprisingly accurate even though it is only held in at the rear.