Supermicro SC846 AIO 360 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket for mounting an AIO 360mm into a Supermicro SC846 24 bay disk rack mount case
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 41
- Wydruki
- 1
- Wyświetlenia
- 725
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A bracket for mounting a 360 AIO into a 24-disk bay Supermicro 846 case.
Requires several other models to work. This model will not fit with the stock hot-swap power supply setup.
Requires ATX Power Supply Mount – https://www.printables.com/model/619733-supermicro-sc846-atx-psu-mount
ATX Power Supply Mount requires slimmer fan mounts – https://www.printables.com/model/638474-supermicro-sc846-rear-fan-bracket-caddy
Made for use with Cooler Master Liquid 360L; however, it should work with other 360mm AIOs. – https://www.amazon.com/gp/product/B0C4C421RZ
These disk mounts should work too, but I have not tested. There is room to tuck in the 2.5" disk mount that comes with the case too, as you can see in the photos. – https://www.printables.com/model/620849-supermicro-sc846-25-hddssd-mount
In addition to screws that come with the case and the AIO, you will also need two M3x8 bolts with matching nuts to mount the bracket to the case on the left side (Left side when the case is viewed from the front).
AIO screws are difficult to insert but doable. AIO screw spacing doesn't seem to be standard, so I included slots to make things easier with other AIO's.
I recommend replacing the AIO fans with something more powerful, such as Noctua NF-F12 iPPC 3000 PWM – https://www.amazon.com/gp/product/B00KFCRATC
I also recommend a PC Slot Case Blower if you have room. – https://www.amazon.com/gp/product/B09BM2MSDF/
In a 25C room with this setup, the computer is quiet and maintains its Ryzen 9 5950X at ~75C at full load, with all disk bays full and spinning. Disks stay at below 40C.
Printed with PETG, Prusa Signal White with 25% infill.