Festool workbench MFT 19 rack mount power strip bracket with cord wrap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Festool workbench MFT. Print for each side of a 1U 19' rack mount electrical power strip. Cord wrap on bottom.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 229
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print two for a 1U 19' rack mount power strip. Cord can be wrapped at bottom. Centered hole can be used for secured locking with M5 x 0.8 x 25 Pozidriv flathead machine screw. It is countersunk 5mm for adjustment. The remainder are sized for M5 x 0.8 x 25 Pozidriv flathead machine screw also.
*Example of a 19" rack mount power strip.
https://www.amazon.com/BTU-Outlet-Protector-Switch-Extension/dp/B0C375Y4BQ?th=1
https://www.amazon.ca/Startech-Com-Cage-Nuts-Server-Cabinets/dp/B00009XT0G?th=1
Use 5M cage nuts if you can find some cheap. They help things go easy since you don't have to hold the nut while tightening. They fit in the flange slots at the ends of the power bar. Mount them on the rear of the bar flange. They just snap in. Then install the power strip behind the brackets to prevent dust getting in the sockets.
*Disclaimer*
I don't have a Festool bench to install the model on. Does it fit?