Slot Car Tyre / Tire Scrubber Truer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very simple, cost effective, robust, slot car tire tyre scrubber for truing and balancing slot car tyres tires
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 150
- Wydruki
- 1
- Wyświetlenia
- 1361
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A very simple, cost effective, robust, slot car tyre/tire scrubber for truing and balancing slot car tyres/tires for the cost of less than a coffee.
You will need;
1. 2x Carrera 20366 replaceable braids
2. 1x PWM Controllers (Dimmer 5V-12V 10A PWM Frequency Adjustable)
3. 1x DC 12v Female Connector (DC Connectors 5.5x2.1mm)
4. M3 Knurled Nuts (x4) + M3x8 Screws (x4)
5. M4 Knurled Nuts (x4) + M4x16 Screws (x4)
6. Wire
You can use any power source between 5v-12v to make it easy on the slot car motor, so use any combination of batteries from 5v up to 12v
The PWM does not change the voltage, so voltage will remain the same, but the PWM will regulate the pulse of the voltage increasing the power, thereby increasing tyre speed
Cut your preferred sand paper 40-45mmW x 160mmL and clamp down between the side clamps
I have soldered the wire connections but you may get away with just twisting them together.
I also soldered the tips of the Carrera braids to just hold them together - they then clip into the lid cavity and are held snug.
Parts can be purchased from any local electronic store or AliExpress
Use any combination of connection to the 12v Female Connector - a few ideas shown in a photo.