Qidi Q1 Pro Filament Cutter ECAS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of Jeffery Strahan's filament cutter for the Q1 Pro that utilizes an ECAS on top and a bowden tube on the bottom
- Ocena
- 4 / 5
- Polubienia
- 65
- Pobrania
- 381
- Wydruki
- 0
- Wyświetlenia
- 2750
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v2.0
I made this remix before learning about Kamsy's. The primary difference is the “body_bottom” on this design accepts a Bowden tube for an optimal alignment to the extruder and it is also rounded to match the top. The tolerances are tightened a bit in order to reduce feeding fails. If your not spot on with your printers flow rate you may need to do more post processing.
Parts
2mm ID Bowden Tube/ PTFE - https://amzn.to/3DDCLIC
ECAS 04 - https://amzn.to/3DDCUvE
#11 Hobby Blade - https://amzn.to/4j2vD92
Pen Spring - From a clicky pen
Directions
- Print the parts
- Insert the blade into each cutter half and super glue them together
- Press the ECAS assembly into the “body_top” half
- Place the glued blade assembly into “body_bottom” and glue “body_top” on
- Once the glue is cured, put the spring in
- Cut a piece of 2mm ID Bowden tube to 9mm and insert into the recess on the bottom of “body_bottom”
Suggestions
I recommend using Capricorn XS Bowden tube (https://amzn.to/4j2w03q) up-stream of the cutter, it has the least resistance and best quality of any Bowden tube Ive tried.