1 / 2
Arduino Nano Bumper (for screw terminal "shield")
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A super simple "bumper" frame for an Arduino Nano adapter with screw terminals.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 223
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A simple "bumper" frame for a small Arduino Nano adapter “shield” with screw terminals.
Printed using PLA, 0.2 mm layer height.
If you want a bit more protection for the screw terminals, there is also a version with sidewalls.
Note that this is not for the “official” Arduino Nano Screw Terminal Adapter. The bumper shown here is for the smaller, simpler adapter that is visible in the photo.