KVM switch button mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder designed to mount the switch from a KVM switch under a desk or on a wall
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 31
- Wydruki
- 1
- Wyświetlenia
- 198
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
A holder designed to hold the 'switch computers' button from a KVM (HDMI and USB) switch and allow it to be screwed to the underside of a desk or a wall. My KVM switch is VPFET-branded, but folks on reddit report that this works for other similar Chinese KVMs from other random brands.
There are 3 versions. One has screw holes at all four corners while the two others omit a hole on one front corner or the other - if you are putting this under a desk pick the one without a screw on the corner from which your finger will be reaching; makes it a bit nicer-feeling to use.
I printed this with 20% infill at 0.2mm resolution. The infill level won't matter much as the structure is almost entirely walls, anyway. You must enable supports to print this. I recommend printing this in the default orientation with the main plate with the hole in face down on the bed - then you just need to snap off three little supports under the screw holes.