Adjustable Thrustmaster's Farmstick

BOM

• adhesive (rubber, double-sided tape, fixed paste, etc.) to the parts in contact with the table, such as the top of the screw (diameter 35) and the bottom side of the top clamp (50x65).

• M6 screws for attaching the joystick

• 2x M3x25 screws 

• 2x M3 Heat-set inserts

Printed parts 

• Desk clamp

• Desk_clamp_screw

• Desk_clamp_screw_top

• Height adjustment screw

• holder_screw_1

• holder_screw_2

• holder_joystick

• Foam rubber_screw (To cut the foam rubber to size)

• Foam rubber_clamp (To cut the foam rubber to size)

Recommended parameters

• Nozzle size: 0.4 mm or 0.6 mm for the bigger parts

• Layer height: 0.15 mm (Structural) and for the bigger parts 0,25 mm

• 6 first and last layers

• min. 4 perimeters 

• Infill : 40%

• Materials recommended: min. PETG (better: PETG CF some stiffer material)

• No support on the thread of the screw

• 100% Infill for the screws, the head of the screw and the cylinder pin

Notes

• All printers have different tolerances, so it could be that the parts are either too loose or too tight for you

• Only intended for holding the joystick and not for leaning on it. You also don't lean on the gear stick of the car ;) 

Update

13.02.2026: I have uploaded a new version. The parts have more play here if you had problems with the first Version.