Twist Lock Present for 4x6 Photographs

I really like 3D Printy's Twist Lock Presents for gift giving. However, I need to fit photo prints inside and they were not big enough.

Since they were generous enough to provide the step files, modifying them was simple enough! I also changed the ribbons a bit to make them multi-material since I have a Prusa XL.

I only made a flat version of this, as it is sufficient to hold around 40-50 photos.

Interior dimensions are now 105mm (4.13in) x 155mm (6.1in) x 16mm (.63in)

Printed in Atomic Indigo Golden Sparkle PLA and Prusament Viva La Bronze PLA.

Printing

Single Extruder

1. Print the parts in the Common folder. You will need 2 copies of the latch.
2. Print the topper of you choice from the original model or other remixes.
3. Print the parts in the Single Extruder folder. You will need 2 copies of each of the ribbons.
4. You will also need to go to the original model and print 4 copies of the flat base ribbon.

Multi Material

1. Print the parts in the Common folder. You will need 2 copies of the latch.
2. Print the topper of you choice from the original model or other remixes.
3. Print the parts in the Multi Material folder. When you import them into PrusaSlicer, say yes when asked if you want to import as a single model.

Assembly

Same as all of the other Twist Lock Boxes. Follow the steps on original model.