Smartphone Buddy

With so many buddies out there, why not add Smartphone Buddy to the mix? He’s your phone’s new best friend, always ready to hang on and keep it company. 

The depth of the cell phone slot is 14mm, which should accommodate most modern smartphones. If your phone’s case exceeds this depth, you may need to remove it. Alternatively, you can use a “Add negative volume” modifier within PrusaSlicer to extend the slot depth.

Set a funny face wallpaper as your lock screen to add some extra fun and give your Smartphone Buddy a playful personality! You can download the wallpaper featured in the preview here if you’d like! (Smartphone_Buddy_Wallpaper.zip)

Print settings

0.2mm layer height works well with 10% rectilinear infill pattern. 

For greater stability, use at least three perimeters!

Remove the part after the print sheet has cooled, then flex the sheet to release it.

I also recommend adding rubber feet to the base to prevent slipping.

Enjoy!

3D Model Usage Disclaimer

All 3D models provided by me are offered free of charge and are licensed under a Creative Commons license. These models are intended for personal and non-commercial use only. Resale, redistribution for profit, or inclusion in any paid product or service is strictly prohibited.

Any unauthorized commercial use or sale of my models constitutes a violation of the license terms and may result in a formal report, takedown request, and potential legal action. By downloading or using these models, you agree to comply fully with the stated licensing conditions.