Modern Doric Table Lamp #2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modern table lamp that doesn't look 3d printed. Base using rough surface (fuzzy skin). E27 fitting and only one tool.
- Ocena
- 5 / 5
- Polubienia
- 347
- Pobrania
- 911
- Wydruki
- 6
- Wyświetlenia
- 5110
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Table lamp consisting of two parts. Only one bolt and nut required.
Materials needed:
- 150gram matte white pla (i used e-sun)
- 250 gram matte black pla (i used creality hyper-cf black)
- 1 m4 bolt and nut
- 1 light fitting e27 (https://www.amazon.nl/dp/B093WWWW3F?ref=ppx_yo2ov_dt_b_fed_asin_title)
- 1 bulb
Print instructions (i have ender 3v3 ke):
- Bottom part (13 hours print)
- 0.12 mm line height
- normal line width settings
- infill for your own prefference
- fuzzy skin:
- create part modifiers in orca slicer to ensure the fuzzy skin is only on the outside surface of the base. This will decreas print time. Make sure to select contour as the fuzzy skin mode.
- 0.2 mm point distance & 0.6 mm skin thickness
- make sure the first cm does not use fuzzy skin!!
- Top part (7 hours print):
- vase mode
- 8 bottom layers
- 0.7 mm line widht (i have 0.4 mm nozzle)
- 0.12 mm line height
- print upside down
- print max 100mm/s
Assembly:
Put the light fitting in the base by putting the plug through the hole and pulling the cable through entirely untill the end. (make sure to check that you buy a fitting that fits entirely through the hole). Use the m4 bolt and nut to keep it in place, don't overtighten.
The top part is just set ontop of the base, no gluing or assembly needed.