RusEFI 64 pin 176122 v0.3 breakout shell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
RusEFI 64 pin 176122 v0.3 breakout shell This was made to prevent shorting pins on the PCB with anything else in the car
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
I made a pretty simple shell for a RusEFI 64-pin 176122 connector breakout (v0.3). I'm using this with a Toyota Camry, but I believe this may also be compatible with the Miata and Hondas.
This really is just to keep it from shorting out on anything when it's wired to a ECU.
I've made a 5mm diameter hole that's 5mm deep hole for a heat set insert for a M3 screw. This lines up with the 3mm holes in the PCB. This hasn't been tested, but fitment is good otherwise. There are two 9mm openings above to provide access to the inserts.
All of the walls are 2mm thick, dimensions are “good enough”, I have no known issues printing this on my P1S.
If heatset inserts need to be modified, I'll upload a v3.