Horizontal Tape Dispenser with homemade blade.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modification of hxr Horizontal Tape Dispenser to hold a homemade meta blade.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 350
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Original description by hxr:
It's a recreation of a Tenex 300 series tape dispenser. I used a 20mm wide metal tape cutter blade from another old dispenser.
The top half can just be pressed on the bottom half and you could fill the holes with sand if you want to make it heavier.
Edit v2:
Made another version of the lower half which can be used with a printed blade. Works less reliable than the metal version but is at least printable ;)
My modification:
I took the 3D printed blade and made it into a blank for adding a homemade blade to the dispenser version 2.
Either you use OpenSCAD to make a holder for your blade or you make one that fits in a 20 by 1 mm hole. The holder needs to be rotated to print easily.
To mount it to the holder I used CA-glue because otherwise the blade came loose, a friction fit did not work for me. The holder and blade does friction fit in the dispenser so no glue is needed there for me.