4.3 inch JKBMS touchscreen display wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This originally had a really bizarre mounting solution, and while this isn't perfect, it's at least usable.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 331
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is certainly not perfect as I was skeptical about the flexibility of the PLA I was using, so the notches which snap into the display's bizarre mounting holes are rather short, but from my testing they're enough for holding the display in. This design accounts for the included rubber spacer on the back of the display's bezel.
Installation
Prepare two ∅6mm wall plugs and appropriate screws as well as two ∅2.6mm x 10mm self tapping screws for the holes at the bottom of the case.
First install the wall plate
Then insert the screen and mount the power button onto the front case (also bend the leads of the switch over to make room for them inside the housing and make sure to snap the cable into the cutout before the next step, you can glue it into place if you want)
After this, align the top 2 notches in the wall plate with the corresponding cutouts on the front case and insert the front case at an angle until they snap into place, allowing you to sit the display flush with the mount
Finally, insert the two screws at the bottom in order to lock the two parts together into place and connect the cable up to the BMS.
