ERCF/Filamentalist 2020 Mounts w/Magnetic Panels

I designed these mounts for the ERCF and Filamentalist setup I've been using lately after running into some conflicting geometry with the original magnetic panels design by Le0n. I've integrated the same magnet spacing into the corners of these mounts and included modified corner sections to mate everything up!

The original magnet inserts are still required for half of the magnetic connections in these corner panels, but you've likely got a few floating around if you were already using the magnetic panels mod.

Magnetic corner pieces can still be used for the top panel, unfortunately this design does keep that panel pretty captive underneath the new brackets. As well, for my 250 spec V2 I had to relocate the midspan clip for both the top and side panels due to conflicts with the filamentalist mount.

As for the 2020 extrusions, these mounts are spaced for use with easy-to-source lengths. My 250 spec V2 has an overall frame width of 410mm so I designed these brackets to work with 400mm extrusions. I'm sure 450mm and 500mm lengths should be similarly easy to get ahold of for 300 and 350 spec Voron printers.

BOM:

M5 t-nuts QTY 8

M5x8mm BHCS QTY 8 (mount to printer frame w/ t-nuts)

M5x16mm BHCS QTY 8 (mount to 2020 extrusions through end holes)

6x3mm magnets QTY 32 (including magnets in original insert pieces)

2020 extrusion QTY 4 (400mm for 250, 450mm for 300, 500mm for 350)

As always, feel free to modify the design to suit your needs! I've attached the STEP alongside STLs for all the required individual pieces