Nomad3 Airblast/mist bracket

Bracket to attach a common coolant mister that's available on amazon to the Carbide 3D nomad3 spindle.

Required Hardware:

• x2 M4x10 socket head cap screws
• x2 M4x30 socket head cap screws
• x2 M4 washers (max ⌀8mm)
• x2 M4 heat set inserts (max length 9.43mm)

Install steps:

1. Prepare the bracket
   • Install the two M4 heat set inserts from the back of the bracket as shown in picture 3.
2. Prepare the mist system by removing blue segments and trim to length the plastic tubes.
   • Unscrew the end and remove both the outer brass cap nozzle and the inner brass mixing nozzle.
   • Remove the end orange segments by bending the loc-line sideways until the segments pop off.
   • Remove the blue segments from the base the same way.
   • Trim the larger plastic tube so that it will land about ½ way down the orange threaded end once attached.
   • Attach the orange end to the base
   • Trim the smaller tube so that it sticks out 1-2mm from the threads when the loc-line is straight.
   • Attach the brass mixing nozzle
   • Attach the outer brass cap nozzle
3. Install bracket to spindle
   • Using the M4x10mm and M4 washers attach the bracket to the right side of the spindle
4. Attach the mist system to the Bracket

IGES and DXF files included for remixing.