Elegant clothes knob with invisible mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple, sturdy knob that seamlessly blends with the wall
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
To install, simply screw the mount onto your wall, align the notch with the cutout at the back of the knob and push it onto the mount. Rotate about a quarter turn to the right and you're done!
Recommended print settings
Use a 'quality' or ‘detail’ print profile. Lower speeds/acceleration will yield a nicer looking part, and could be necessary to correctly print the small mount.
Knob:
- Layer height: 0.2 or 0.16 mm
- Initial layer line width: ~0.4 mm
- 3 walls
- 4 top and bottom layers
- Concentric bottom surface pattern
- 30% infill
Mount, same as knob except for:
- 100% infill
- Enable supports
Note: the tolerances used in this design are quite tight (0.1 mm), as I didn't want any wobbling. You could scale the knob up or the mount down by 1 or 2%, if required.