overhang test
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quick 360° cooling test, overhangs 40–75°, steady head motion without mechanical strain.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 185
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A Few Words of Introduction
This is a quick test designed to check print cooling efficiency across 360° without putting excessive strain on the printer’s mechanics. The printer can operate at a steady, uniform speed without unnecessary head movements.
The first segment starts at a 40° overhang, each following segment increases by 5°, and the test ends at 75°. You can print the full model or scale it down, e.g. to 60%.
Recommended print settings:
Infill: 0%
Top layers: 0
Walls: 2
I recommend adjusting the slicer settings so that up to half the model height you print with 2 walls, and above that height switch to 3 walls.
Postscriptum
I needed a quick and simple 360° test for my new print cooling system. I couldn’t find anything that would check overhang quality across the full 360° range with angles from 40° to 75°, while keeping the head movement uniform (without unnecessary acceleration or deceleration).
CONCLUSION 💚💚💚If you enjoyed the project please like it.💚💚💚 Post your makes and let me know how it works out for you. If anyone has any comments about them - I'd be happy to listen and improve the models. ☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕ Did my project bring you joy, save you time, or solve your problem? Share your experience with me and brighten my day—buy me a Ko-fi! ☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕☕ |