Gridfinity Stackable Electric Precision Driver & Bit Storage 1x5x6u
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stackable Gridfinity holder - holds 25 4mm driver bits and a precision electric screwdriver.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This design uses up to 20 6x2mm magnets, but you can use as few as you desire. They slip into place easily and can be removed with a pick. I made this compatible with a gridfinity “rugged” box for storage. When stacked with other bins, or stored in a gridfinity box, all the bits and the driver are retained.
No special print settings are required, but I recommend ensuring your slicer properly generates the bridges for this model, they must be perpendicular to the slot for removing the magnet. Like this;
If it is not printed like this, the magnets will not fit. I had this issue on my first test print. In OrcaSlicer, I fixed this issue by setting “Bridge counterbore holes” to “Partially bridged.”
I printed my model in Sunlu PLA High Speed at 220c, with a max volumetric speed of 21mm^3/s.
I'm not sure exactly what drivers will fit in this holder, so I included a dimensioned drawing so you can check for proper fitment.
Good luck and happy printing!