Hanger Rail for Modulex Planning Board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
The Modulex Planning System 125cm by 50cm board has brackets on the back to hang it on a wall, however mine was missing the mounting cleats when I got it and only had the board-side brackets. This is a small section of cleat that can be stuck to a wall or other vertical surface with 3M Command Strips (large size).
I printed this rotated, sitting on its back (the wall side) so that I would have a nice flat surface for the 3M Command Strips to stick to. This meant that I needed a material with good inter-layer adhesion, so I used 3D-Fuel's Tough Pro PCTG. Used 5 perimeters, an 0.6mm nozzle, and 20% honeycomb infill, and that worked great. Just make sure when you stick them to a surface that you have each side perfectly level with each other so the board hangs correctly and distributes the weight properly.